Tell you how to prevent wear and dust on industrial conveyor chains

Chain wear is very common in the process of use. Today we will look at how to prevent unnecessary wear of industrial Conveyor Chains?

Follow our recommended maintenance procedures for industrial conveyor chains.

-When changing speed, please try to keep the verticality of the industrial conveyor chain between the large Gear and the flywheel (for example, do not use the smallest gear with the smallest flywheel, or the largest gear with the largest flywheel and other extreme gears.)

-When changing speeds, consider road conditions in advance (for example, when uphill, upshift early to avoid changing gears, excessive force is added to the industrial conveyor chain.)

-Before stopping, please change to the smallest gear, so as to avoid the need to change speed when stationary.

 Some riders use 2 or 3 conveyor chains at the same time and replace them weekly (or every 500-700 kilometers). It is said that this can reduce wear and tear, especially for more expensive gears and flywheels.

How to reduce dust on the surface of industrial chains

The industrial conveyor chain is not only easy to apply and has a long service life. However, customers often expose the industrial conveyor chain to the outside air during use. Because its surface is not protected by any items, although it has its own lubricant on the surface, once the oil gets on it, The dust industrial conveyor chain will become dirty, and over time, the entire chain will be affected and darkened. Today we will make a specific introduction to this situation:

First, clean and lubricate the industrial conveyor chain regularly. It is necessary to know that after the lubricating oil is added, you need to wait about 30 minutes to several hours for infiltration, and then wipe the excess oil with a rag. The surface of industrial conveyor chains feels almost oil-free to the touch. Infiltration into the shaft of the industrial conveyor chain can better achieve better lubrication effect.